Spare set screws (1 pair) for securely fixing the drill bit in the drill chuck. Suitable for Easyfix drills, types 1–5. Technical data: M8 external thread, 4 mm internal hexagon.To change the drill bit, slightly loosen the side grub screws. Then pull the drill bit out upwards and insert the sharpened or new drill bit so that the flattened side faces towards the grub screws. Then tighten both screws hand-tight again.

Replacement motor Bosch GWS 2200 (220V/6,500rpm) suitable for Easyfix drill type 5. The angle grinder is already prepared for direct installation.IMPORTANT: Electrical work may only be carried out by qualified electricians or under their direction and supervision. Always disconnect the appliance from the mains supply before carrying out any work!

Bosch GWS 2200 angle grinder (220V/6,500rpm) suitable for the Easyfix Type 5 drilling machine. The angle grinder is supplied ready for direct installation. IMPORTANT: Electrical work must only be carried out by qualified electricians or under their supervision. Always disconnect the machine from the mains before carrying out any work!

Spare part suitable for the Easyfix drilling machine, types 1/2/3/4/5.A straight and fully functional distance bar is essential for precise drilling. If it is bent, it should always be replaced to ensure the tree can be correctly aligned during drilling. If the rod no longer locks properly, preventing it from being adjusted to the relevant tree size on the stainless steel rod, we also recommend replacing it.

Drill chuck with optimised chip removal. Compatible with all Easyfix drills of types 2–5. The bevelled design allows for efficient lateral chip removal during drilling.Internal thread: M14Drill chuck: Ø 16 mmDimensions: Height 64 mm, Ø 30 mm

Electrical unit including on/off switch and emergency stop. Compatible with all Easyfix drilling machines, types 2/3/4/5.IMPORTANT: Electrical work must only be carried out by qualified electricians or under their supervision. Always disconnect the machine from the mains before carrying out any work!

Standard funnel with 37 mm opening. Suitable for Easyfix drilling machines type 2/3/4/5.

Special tapered drillbit with a diameter of 16 mm, made from high-alloy tool steel. Suitable for Easyfix drills types 1/2/3/4/5. Designed for drilling holes in Christmas trees for display and setting up using the Easyfix system.Lifespan: approx. 3,000 drill holes. The drill tip can be re-sharpened afterwards.Required shank: 16 mm

Maintenance-free dry plain bearings made of plastic (internal diameter: 18 mm). Suitable for Easyfix drilling machine, types 2/3/4/5.The bearings are fitted in pairs on both sides of the carriage to which the angle grinder is mounted. Here, they ensure that the component glides smoothly along the two chrome rods, thereby enabling the machine to be operated effortlessly via the foot pedal.Important: This is a dry plain bearing. It is not necessary to grease the bearings!To replace the bearings, release the chrome rods from their mountings in the machine and pull both rods out. Using circlip pliers for bores (internal rings, i.e. the pliers close when squeezed), remove the upper and lower circlips securing the bearing in order to replace it. Then reinsert the circlips, reinsert the chrome rods and secure them.

5 m power lead including Schuko plug (protection class IP44), suitable for Easyfix drills types 1/2/3/4/5 and for the tree-shaking machine (item no. 44800). IMPORTANT: Electrical work must only be carried out by qualified electricians or under their supervision. Always disconnect the machine from the mains before carrying out any work!